Recommended Posts

Posted

http://www.farmandfl...rkers_vise.html

im planing on making a smaller craft bench for carving and a little hand tool work. my bench is only going to around 20"x 52 or 60" i thought that i could buy 3 of these to use for a end vice and then put one on eather side of my bench perhaps i can join them together with one long board and using them in conjnction.Then i can use it for tapered work or in case i have longer boards like if im planing down the edge of a 6 ft board. would this work? is it not going to hold my boards while im using a chisle or plane on it?

also is a 20 inch bench not going to be stable enough to keep it from rocking? might end up bolting it to the basement floor to be safe.

Posted

I have 2 of these on my bench (20"x48"). One is setup as an endvise and the other is a front vise. I attached some scrap oak to the jaws. The boards I used were longer than the jaws, which gives the vice a bit more holding surface area. They seem to work well or at least better than what I had before - no vice :)

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.