Recommended Posts

Posted

Hey Marc & forum!

I am currently working step by step on the Adirondack Chair.

Yesterday, I bought the Powermatic bench top model mortiser.

I followed the instructions on setup and started doing test cuts.

Unfortunately, the cuts are not as clean as shown in the video as there are minor grooves (1/64th or less) where the auger bit rotates outside the edge of the chisel on the plunge cuts.

I think the mortises would still work but I would like to make them cleanly and properly.

The bit I bought was only $25.00 as it was my only choice at the time.

Is this slight unevenness due to the quality of the auger and chisel bit being inexpensive or am I doing something wrong with my setup?

001_800x600.jpg

Posted

I ran into this some problem with mine. What I did to correct this was to take a fine metal file and while the auger is running slowly bring the file flush against all 4 outside edges of the chisel. This will remove the excess part of the bit that travels outside the cutting area. When you no longer hear any contact with the file its good. I did this with all my sizes and it tool take of the problem. This is what mine looked like before I did the correction. Unfortunately I don't have an after pic.. But it worked for me.

post-6031-0-39784000-1324164967_thumb.jp

Posted

Now that's a good idea... I got rid on my mortiser years ago, but I just lived with the problem (only on the 3/8 chisel) -- did not really effect strength, and I chopped through mortises by hand -- so it was never an issue for me -- but it bothered me none the less...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 50 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined