shann123 Posted January 17, 2013 Report Posted January 17, 2013 So I have another question or two about this project, but I need to get some drawings or sketchup images before I can those. For the legs I'm gluing up two pieces of 4/4 ash to make 8/4 legs. For the should I chop out half-mortises (for the aprons) before gluing up then use a block to align the glue up (make two "double-stopped rabbets" (there's probably a better term for this)), or should I do the glue-up then chop out the mortises? Thanks. And I know this would be much easier to comprehend with a drawing at least. Joe Quote
Bombarde16 Posted January 17, 2013 Report Posted January 17, 2013 Unquestionably it's easier to cut mortises first and then glue the legs together. But doesn't each leg need two mortises at 90 degrees? (Your idea would be great for the headboard on a mission style bed.) But for a normal table leg, it's better to rout out the mortises all at once with a single setting on the router. Quote
estesbubba Posted January 18, 2013 Report Posted January 18, 2013 I'm working on some mission tables and also have 8/4 legs made from gluing 4/4 stock. I would definitely glue the legs first. You have several points of alignment problems cutting first then gluing. Face glue your stock and cut yourself some nice square legs then do your mortises. Here are the legs with mortises I just made. 1 Quote
jHop Posted January 18, 2013 Report Posted January 18, 2013 I think it also depends on where the mortise falls between the two pieces that get glued up. If, for example, the mortise will only be in one board, chop it out before glue up. (I've heard of people using packing tape on a spare piece of scrap to keep integrity.) If it is centered between the two pieces, it might be better to chop the two halves out, but you will need to do a lot of cross-measuring and reassuring of your layout lines before you do. If they are not going to be centered, I'd glue them up and then cut them. Also, if you are going to do some perpendicular to the glue line instead of in line with the glue (that is, the bottom of the mortise is accessed by going through the glued faces), I would not bother doing any other method than glueing first and mortising second. But this is just my approach. Quote
shann123 Posted January 18, 2013 Author Report Posted January 18, 2013 Thank you all for the responses. I was worried about lining up two half-mortises, and Rob is right, I do have to create mortises on 2 faces of each leg anyway, so I'll glue up first then router/square up the whole mortises. Quote
shann123 Posted October 17, 2013 Author Report Posted October 17, 2013 Since I never kept this updated I decided to finally just post it in the project showcase forum Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.