RJsumthn Posted May 2, 2013 Report Posted May 2, 2013 To add to the complexity I want to round over the outside of the joint. I know how to make it in the shop but I can't figure it out in Sketchup. Does anybody have any ideas? Quote
Byrdie Posted May 12, 2013 Report Posted May 12, 2013 I would take one side of the component, round it over and then draw the dovetails. After that I would copy and "paste in place." I'll have to try it tomorrow in the morning and see if I'm on the right track. If it works I'll up load the results. Quote
Byrdie Posted May 13, 2013 Report Posted May 13, 2013 Tried last night after I logged off and it didn't work quite the way I imagined. I was able to draw a joint with dove tails and I was able to draw a joint with a rounded corner. I wasn't able to combine the two. But I'm not done trying either. Quote
RJsumthn Posted May 13, 2013 Author Report Posted May 13, 2013 haha thanks Byrdie!! It's times like this where I wish I still had AutoCad. Quote
Dan S Posted May 13, 2013 Report Posted May 13, 2013 Are you saying you want through dovetails that then has the corner rounded over? Quote
Dan S Posted May 14, 2013 Report Posted May 14, 2013 This is what you want to do then. I attached some screenshots of doing it with dovetails Quote
Dan S Posted May 14, 2013 Report Posted May 14, 2013 the rest of the screen shots and the model. model.skp Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.