Shannon1066 Posted September 2, 2013 Report Posted September 2, 2013 I'm pretty sure this is user error but I am frustrated not being able to lock in the fence on my Powermatic 8" jointer. I can get it square but when I push wood against it, it moves about 25 thousands. The result is my board not being square. Does anyone have a tip or suggestion on how to keep it locked where I want it? Thanks Quote
Tom King Posted September 3, 2013 Report Posted September 3, 2013 What model 8" jointer. Here's the manual for one model. Some part is missing, broken, or out of adjustment. Look at the stops first. They are adjustable. http://content.powermatic.com/assets/manuals/1610086K_man_EN.pdf Quote
T-astragal Posted September 3, 2013 Report Posted September 3, 2013 I drilled through the casting and left the drill bit in the hole effectively locking the joint. It is a little crude I know, but Taiwanese is Taiwanese in any color!Steve Quote
Shannon1066 Posted September 3, 2013 Author Report Posted September 3, 2013 It is the 60HH 8" Powermatic. I've followed the manual as best I can and set the stops. I certainly hope nothing is missing. It would be hard to determine. Quote
Trip Posted September 3, 2013 Report Posted September 3, 2013 I've never used the PM-60 or any other jointer with this particular fence mechanism, so the obvious caveats apply... I've taken a look at the manual and have the basic gist... To clarify, with the fence at 90deg, resting against the stop and the 'lock' handle engaged, you can press against the fence and get 0.025 deflection? Since the stop is set at 90deg, I'm assuming you are deflecting to 89.975? Does the lock-handle tighten-up prior to 'bottoming-out', so the locking mechanism torques-out prior to running-out of room to tighten? i.e., you can't tighten the locking mechanism further, even if you had more room to tighten? Since the mechanism is gear-driven, how much 'play' is there in the gearing? Quote
Tom King Posted September 4, 2013 Report Posted September 4, 2013 Check this part on that schematic. 21.............PJ882-121 ...............Stop Block............................................................................................. Looking at the way it works, I'm betting on someone trying to adjust it with the wheel without unlocking it. Quote
dwacker Posted September 4, 2013 Report Posted September 4, 2013 Your stop should not be needed to hold the fence at the desired position. Stops are only a quick reference point so that the fence can be returned to the same position. If the lock is slipping causing the fence to go out of square you will have to tighten the lock. If you cant tell in the manual how to tight the lock call PM support and they will step you through it. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.