Recommended Posts

Posted

Most of the time, I don't think about the process much.  Today, I sharpened a couple of backsaws, and decided to analyze anything I might do differently than what's been seen in other videos.  I didn't have anything to take a video with, but I did try to come up with more important details that have been left off in videos I've seen.

 

The most important thing I came up with was  Where to Look, or where to focus your attention.  You can't see what the file is doing in the gullet anyway.  I look from a little bit behind the tooth being filed.  That way you can see how much of the flat you are taking, and focus needs to be from a point that you can see both the jointed flat, and where the file will land next.

 

My position is not straight out, perpendicular to the vise.  It's angled a little behind the file.  I don't mark the teeth any kind of way, but from this angle, you can see which way they are leaning.

 

I filed a 19 pt. crosscut and 13 pt. rip backsaws.  It only took a few minutes.  Both saws were small enough that I didn't need to stop and move them in the vise.  I was not using magnifying glasses, but used a magnifying stand light that I bought from Lowes.  It worked okay.   Normally, I use the dental loupes, but I wanted to see the big picture today.

 

I used light, full strokes with a 4" double extra slim file for both saws. I would have liked to have a smaller one for the 19pt., but it was the smallest file I had.  That was the first backsaw I ever bought-never used it much, and had never sharpened it.

 

 For the shoulder cuts I've been doing with the rip saw, down a 2-1/4" long tenon, stroke count went from 14 down to 6 without trying to get in a hurry. The saw was way overdue for sharpening.  They both work like a charm now.  With the crosscut saw, I'm sawing an 1/8" thick piece down 1/8".  The fine toothed backsaw had been the only saw I had that wouldn't chip out the thin Heart Pine.  Now I make that cut with the sharpened saw only by backing it up for a vey short stroke.  I'm using a small router plane to mark the depth,then cut the waste off, and level the bottom after the saw cuts.

  • Like 1
Posted

Good tips...I have a backsaw that I need to sharpen, but I need to wait until I have the proper file.

 

I never considered the need for a magnifier  - do you think it's a neccesity, or just handy?

Posted

It depends on your eyes.  I'm 63, and never wore glasses, but I need a little help on a 19 pt. these days.    The 4" extra slim was a little big for the 19 pt., but it was the smallest I have.  I did order a needle file from Lee Valley when I got home yesterday.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.