JoshC1501 Posted February 25, 2014 Report Posted February 25, 2014 I picked up a few Narex chisels awhile back. Just really started using them. They are really sharp with a 30 degree micro bevel. I seem to be getting a lot of really small chips in the edge pretty quickly. I did some research on here and sounds like it is pretty common for the first 1/16 of an inch or so of steel. Thoughts or this just normal for this grade of chisel? Should I try a different angle on the micro bevel? Quote
ChrisG Posted February 25, 2014 Report Posted February 25, 2014 That's pretty normal. You can grind them back, but unless they are totally intolerable, I would just use them and before too long rehonings will take care of the problem. Quote
jhl.verona Posted February 25, 2014 Report Posted February 25, 2014 Totally agree with Chris. Just keep honing, they get better with time. No need to grind. As a beginner I didn't really notice (thought it was me) so the initial hump wasn't so bad. In any case, I'm gradually coming to the conclusion that it's better to sharpen before you need to, rather than later. As with most things, practice makes perfect, and above all makes fast. John Quote
CessnaPilotBarry Posted February 25, 2014 Report Posted February 25, 2014 I don't grind once the angle is established. I prefer to do the primary bevel on DMT XC-C-F-XF plates, 5-10 strokes each, then a micro bevel on 4000 and 8000 grit waterstones. The diamond plates will remove the chips, not change the temper as grinding can, and they always stay flat. The XC can also do double duty, keeping the waterstones flat. 1 Quote
G S Haydon Posted February 25, 2014 Report Posted February 25, 2014 Josh, as you thought you are not alone with this. Keep using them and you'll be fine. They are very good chisels. Quote
JoshC1501 Posted February 25, 2014 Author Report Posted February 25, 2014 Thanks for the input guys! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.