Wooddiva Posted March 12, 2014 Report Posted March 12, 2014 I recently purchased a Deluxe 1/2" Rabbeting Set that had 7 bearings included with the set. I needed it to cut the rabbeting on the back of a picture frame. However, I am having some difficulty. I have never used a bit like this before so I am unsure if I am putting it together correctly or not. I put a washer that came with the set on top of a bearing that would give me the desired width cut. the washer did not fit flush inside the bearing before attaching the screw. However, when I started the router up it started sending sparks at me very quickly. I know I did something wrong but there are no instructions or informative papers with the kit and I have yet to find anything to help me on the internet. Is there any information anyone can give me to make this a task that I can get done with? I have just recently started using a router and there is a lot I need to learn. Any information you can give me would be greatly appreciated. Thanks a lot guys! Quote
wdwerker Posted March 12, 2014 Report Posted March 12, 2014 Can you post a link or picture of the rabbiting set? What brand is it? Quote
Wooddiva Posted March 12, 2014 Author Report Posted March 12, 2014 Honestly it is a Roman Carbide.....I got it off of Amazon. Had several bits I needed to buy and needed to stay within my budget. Here is the link to the ones I purchased..... http://www.amazon.com/Roman-Carbide-DC1827-Rabbeting-Bearings/dp/B005W19WQK/ref=sr_1_4?ie=UTF8&qid=1394656508&sr=8-4&keywords=roman+carbide+router+bits There are seven bearings that go with it and I'm trying to do a 1/4" rabbet for the back of a picture frame. Not sure what I did wrong but very shortly after I started the router I got sparks and immediately cut it off.... Not sure if I put the wrong washer on for the bearing size or what. Can't find anything to tell me on the internet searches I have done. Thanks for helping if you can!! Quote
rodger. Posted March 12, 2014 Report Posted March 12, 2014 Honestly it is a Roman Carbide.....I got it off of Amazon. Had several bits I needed to buy and needed to stay within my budget. Here is the link to the ones I purchased.....http://www.amazon.com/Roman-Carbide-DC1827-Rabbeting-Bearings/dp/B005W19WQK/ref=sr_1_4?ie=UTF8&qid=1394656508&sr=8-4&keywords=roman+carbide+router+bits There are seven bearings that go with it and I'm trying to do a 1/4" rabbet for the back of a picture frame. Not sure what I did wrong but very shortly after I started the router I got sparks and immediately cut it off.... Not sure if I put the wrong washer on for the bearing size or what. Can't find anything to tell me on the internet searches I have done. Thanks for helping if you can!! Is the frame already glued and assembled? If so, Did you use any Metal in the project? Did you hit a buried nail or screw by chance? Quote
dwacker Posted March 12, 2014 Report Posted March 12, 2014 Just make sure the bearing is spinning freely. Quote
Dlhunter Posted March 13, 2014 Report Posted March 13, 2014 use the smallest washer that will hold the bearing on. If you are using a washer that is nearly the size of the bearing it may be contacting both the inner and outer ring on the bearing. Or just take it apart and see what looks like it was metal on metal friction. Scratches ect... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.