Identify this Router Bit?

[declan]

I'm new to the board and wondering if anyone can help identify this for me: I have a piece of molding from my neighbors house that's rotted and we're trying to find a router bit that will allow me to route new molding to match (as closely as possible) the existing.

I've attached a picture. Anyone happen to know where I can find a router bit to handle this cut?

The piece is about an inch and a half wide.

Thanks!

[Justin57]

I'm new to the board and wondering if anyone can help identify this for me: I have a piece of molding from my neighbors house that's rotted and we're trying to find a router bit that will allow me to route new molding to match (as closely as possible) the existing.

I've attached a picture. Anyone happen to know where I can find a router bit to handle this cut?

The piece is about an inch and a half wide.

Thanks!

EagleAmerica.com and MLCSwoodworking.com have a very big selection of bits. If you saw about a 1/4" piece off the end you can take that right to your computer and compare the profile to the bits, you should find just what you need.

[declan]

Thanks, I'll try EagleAmerica. I have the piece with me, but after looking through Rockler, Woodcraft and MLCS, I didn't find a good match. Closest I found was a door frame bit, but that's a lot wider.

EagleAmerica.com and MLCSwoodworking.com have a very big selection of bits. If you saw about a 1/4" piece off the end you can take that right to your computer and compare the profile to the bits, you should find just what you need.

[Sac]

Look at these.. Might be able to find something similar..

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_molding.html