Illini40 Posted December 9, 2014 Report Posted December 9, 2014 Are there any limitations /challenges with the length of lumber when using a table top jointer? I'm assuming with a smaller table, longer pieces of lumber could be a little tricky. But just how tricky? Any specific lengths based on your experience? I'm thinking that some type of out feed table or support could be used in conjunction. Quote
Bill Tarbell Posted December 9, 2014 Report Posted December 9, 2014 In/outfeeds would be helpful for supporting long stock, but it's still only as accurate as the bed length. If you're running a long piece on a short bed then you would also need to press down with more pressure when you're nearing the ends of the board. If the jointer is lightweight then it may be prone to tipping. I've never used a bench-top model so this is purely speculation. When i ran 7' x 3" x 2" oak boards through my 6" jointer without in/outfeed rollers i accidentally caused the jointer to start to tip when pressing down the tail end of the board. I'm not so sure that the presence of a roller would have made much difference since the roller can't be the same height as the jointer or else you run the risk of it messing up your result. I'd have the roller at least 1-2" lower than the tables .. but then you'd still need to press the board down firmly so it stays flush with the jointer tables. The rollers would just be for allowing the board to relax before/after you're planing. Quote
pghmyn Posted December 9, 2014 Report Posted December 9, 2014 I extended the outfeed bed by 30" with a piece of MDF. Worked like a charm. That was before I purchased the machine I have now, but it worked and worked well. Quote
..Kev Posted December 9, 2014 Report Posted December 9, 2014 There are workarounds but, if you just need to save a little longer then I'd save. If it's a space issue, then some of these workarounds might be what you need. Quote
knotscott Posted December 9, 2014 Report Posted December 9, 2014 If there's any way to fit a 6" floor unit into the mix, that's the way to go. The bench units are much louder, less accurate, have limited capacity, and a lot less mass. If you've really got to go with a bench model, you'll be limited to smaller pieces. Quote
TerryMcK Posted December 9, 2014 Report Posted December 9, 2014 I'd say on a table top jointer bolt it down to a stable platform stop tip ups. I still have a redundant one on a storage rack (probably need to get rid of it) and never felt comfortable with anything longer than two to two and a half times time the length of the infeed table. Obviously not using heavy stock on without supplemental support from roller stands. It all depends upon the type of work you want to do - the ones I've seen (and mine) are also extremely noisy being fitted with universal motors. One of the reasons I got a full size floor mounted one - my ears thanked me for it though I still wear ear protection. Quote
mikem Posted December 9, 2014 Report Posted December 9, 2014 Go for a floor model jointer. I had a bench top for a few years, and i was always adjusting and readjusting it. Anything over 30" long was near impossible to joint on it. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.