mandobrit Posted February 2, 2015 Report Posted February 2, 2015 I purchased a DeWalt biscuit joiner a couple of years ago and had a lot of problems with slots not being parallel, approx. 0.010" difference with #20 biscuit. I finally found an answer at the DeWalt website that said to loosen the two screws just above the points that hold the wood from slipping. I noticed that there was a 1/16" step between my base and the supporting block which was set at the factory, I presume. I made the supporting block, as they call it, flush with the base, but it was still out 0.010". I lifted one side 0.010" higher than the base and it fixed the problem, but when I put a square on there was of course a big gap back to front on one side because the supporting block was higher than the base. DeWalt service said they could put new parts on it for $120 but no gaurantee it would fix the problem. No Way! I am now looking for a new biscuit joiner. I have done some research and it seems the Porter Cable 557 is highly recommended. Here in Canada it is $289, $40 more than the DeWalt which I would never recommend anyone buy. Lamello is way too high a price for the work I do, so not many other options. Any ideas would be appreciated. Quote
CessnaPilotBarry Posted February 2, 2015 Report Posted February 2, 2015 You ask far more from a biscuit joiner than I ever have... Have you measured a bunch of biscuits yet, and noticed that they vary? Quote
Eric. Posted February 2, 2015 Report Posted February 2, 2015 Biscuits are for alignment during glue-up, not for joinery. If a biscuit joiner isn't accurate enough for you, you're using the wrong tool for the job, and I agree with Barry that you're expecting it to perform in a way that it was not designed to perform. 1 Quote
dwacker Posted February 2, 2015 Report Posted February 2, 2015 Biscuits are for particle board, not much good for much else. Quote
rodger. Posted February 2, 2015 Report Posted February 2, 2015 If u are in Canada, look on kijiji. I have the pc model, and it works great. Quote
Jerry_in_SD Posted February 3, 2015 Report Posted February 3, 2015 I own a P-C 557 I got years ago. I've only used it for alignment aids for panel glue-ups and help with some miters. I agree with other posters that they aren't much for joinery. If it broke tomorrow, would I replace it? Not likely. Maybe save my dimes and and buy a festool someday . That said, it appears to be a quality tool for what it does. Btw, I have a slot cutting router bit that is width of biscuits. Not as fast as dedicated tool but seems more accurate since it references exactly off one face. 1 Quote
wdwerker Posted February 3, 2015 Report Posted February 3, 2015 I rarely use my Lamello Top 10 anymore. Make me an offer! Quote
CessnaPilotBarry Posted February 3, 2015 Report Posted February 3, 2015 Btw, I have a slot cutting router bit that is width of biscuits. Not as fast as dedicated tool but seems more accurate since it references exactly off one face. These are GREAT for cutting alignment grooves, using biscuits as the splines. A lot faster than the handheld tool, too... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.