shawnm Posted March 11, 2015 Report Posted March 11, 2015 Hey guys I bought a used table saw last year its a mastercraft 55-6833-2. It's a table top kind. I am wondering if it would take a dado blade? The insert is about half the size of a full table or cabinet saw. Quote
minorhero Posted March 11, 2015 Report Posted March 11, 2015 Typically the answer is no for those small saws. You will want to see if the arbor has enough room on it to put a dado and still tighten down properly. Then again you might be able to get something small on there, not a full 1 inch but you might fit a 3/8 inch. Quote
shawnm Posted March 11, 2015 Author Report Posted March 11, 2015 Thanks for the quick reply, I've been trying to find a manual online and been having trouble. I have done some google search's and from what I see I might be able to fit up to 1/2" dado. But 3/8" would definitely be better than a 1/8" blade. Quote
Dave H Posted March 12, 2015 Report Posted March 12, 2015 If you did get a dado set on the saw you would have to make a ZCI because the metal insert on most sidewinders is for standard blade clearance. A dado set even if you could put one on the saw might be to taxing for the under-powered motors, the dado set has a lot more mass than a standard blade, when advancing your work through the dado set the extra mass plus the extra load of the wider trough being plowed out could burn the motor up. Quote
shawnm Posted March 12, 2015 Author Report Posted March 12, 2015 I guess it can take a dado. I would go for a 6" blade and it would be slow going. Now i've never used a dado blade before, so do you buy a blade thats 3/8" or 1/2" or is it how you stack the washers and whatnot inbetween the blades that give the width? Quote
Vyrolan Posted March 12, 2015 Report Posted March 12, 2015 The best solution (IMHO) for the jobsite saws is something like the 2-piece box joint sets. http://www.amazon.com/Freud-SBOX8-Cutter-4-Inch-grooves/dp/B000ASGV1E It will do either 1/4" or 3/8" width which is a lot mode than the 3/32" on the thin kerf blades. Is it the best solution? No but you have a jobsite saw... Are those blades really designed for dado work? No but you have a jobsite saw... Depending on what you want to use it for, it could be more than sufficient. 1 Quote
dwacker Posted March 12, 2015 Report Posted March 12, 2015 You need to actually check your saw. Make sure that if you stack a second plate it will stay centered. Many saws even though they have a dado capacity spec don't have machined threads. Dado is a generic term for the end result of the cut. If your threads are not machined to the same diameter as the shaft then you need a thick kerf blade to make dados on your saw. Quote
shawnm Posted March 12, 2015 Author Report Posted March 12, 2015 I'll have to check it out. I'm waiting for warmer weather anyway thanks guys Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.