collinb Posted April 29, 2015 Report Posted April 29, 2015 At a local auction yesterday there was a LumberSmith. Didn't go for much but I didn't have the need for it. But I just loved the sign on its blade shield. And my table saw ... the pully has been sliding. The set screw keeps working loose. Should I use red or blue Loctite on it? Quote
RichardA Posted April 29, 2015 Report Posted April 29, 2015 Check your keyway, it may be worn.... I have a Craftsman to and that was the problem I had with the pully coming loose regularly Quote
collinb Posted April 29, 2015 Author Report Posted April 29, 2015 Check your keyway, it may be worn.... I have a Craftsman to and that was the problem I had with the pully coming loose regularly I think it is. That would mean replacing the whole arbor, would it not? Mine is also Craftsman. Quote
Guest Posted April 29, 2015 Report Posted April 29, 2015 I like that sign. I might have one made like that for my shop wall. Quote
RichardA Posted April 29, 2015 Report Posted April 29, 2015 I think it is. That would mean replacing the whole arbor, would it not? Mine is also Craftsman. No, the keyway is a small piece that sits inside the grove of the arbor. It's curved to fit the grove and the notch in the pully slides over the keyway.... You just knock out the existing keyway, take it to any hardware store and get a replacement. The cost is outrageous 20 or 30 cents! Buy 3 or 4 so you always have a replacement... You can add a drop of red Loctite to your set screw, but remember it will make loosening the set screw a little harder. Quote
collinb Posted April 29, 2015 Author Report Posted April 29, 2015 No, the keyway is a small piece that sits inside the grove of the arbor. It's curved to fit the grove and the notch in the pully slides over the keyway.... You just knock out the existing keyway, take it to any hardware store and get a replacement. The cost is outrageous 20 or 30 cents! Buy 3 or 4 so you always have a replacement... You can add a drop of red Loctite to your set screw, but remember it will make loosening the set screw a little harder. Gotcha. I always call it the key and the slot the keyway. But that's ok. An easy fix. 15 minutes will cover it. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.