Recommended Posts

Posted

Is whuppin my butt.. after using my saw for two years splitter free, I've decided that I've tempted fate for too long and it's past time. I followed the install instructions to the T and after setting up the first one, it was to right to the fence, I slowed down on the two remaining zci's I had and all three came out putting too much pressure on the fence.

Is there a learning curve in these setup's? It seems stupid easy and I keep messing it up.

Posted

I had to play with mine for a while as well. I am pretty sure that the splitters are different sizes. They have the plus signs on them to let you the different sizes. I just kept switching out the splitters until it worked like I wanted it. I hope this is useful.

Sent from my iPhone using Tapatalk

Posted

Brad, one side had nothing, I assume that is not offset at all to the fence side Then getting tighter as "featherboards" with increasing + signs up to +++. None of them fit. The clear one being the closest.

Assuming I have just set up wrong,on 3 different inserts, is it stupid to take a sander to that one removing a tiny bit at a time until it works?

Posted

I don't want to give you horrible advice and have a board get kicked in your face. But... If your fence is perfectly aligned to the blade and you are talking a very small adjustment, I would open the back of my fence.

This might be to obvious but I know they make two different jigs. One for full kerf and the other for not full kerf blades. If all else fails and you can't figure out a solution then I would sand it down. As long as it is keeping the wood from pinching the back of your blade you are better off then having nothing.

Sent from my iPhone using Tapatalk

Posted

It looks like my fence is out about .010 of an inch. I hope this is helping. Here is a picture of the set up I used. I am sure yours is the same. 8a47a9f9d569db45b512558a4036179a.jpg

I remember now why I had a problem. It was because the bottom of the splitter. The round part was sticking up just a little bit. 5556554c572b48b6f38369f162ca23ff.jpg I know it is hard to see but I ran enough boards through that it cut through the round plastic at the bottom.

Sent from my iPhone using Tapatalk

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 42 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined