Recommended Posts

Posted

Got a little closer to finishing today; picked up the badges so I can fit them in place and cut recesses for them to sit flush.  Also, cut the base but still have to cut the angle to allow the front to slant back 15°.  I'll get that done tomorrow and might get to start shooting the finish on but I need to make a Walnut run and that's going to take a while to get over to the sawmill and back.

Base cut -
009%20-%20Curves%20toward%20rear_zpsjvct

Testing badge locations for spacing -
010%20-%20Badges%20testing%20for%20locat

Cutting recess for fasteners -
011%20-%20Cutting%20recess%20for%20badge

More later!
David

  • Like 1
Posted

Side question, how do you acquire the badges?  Are they from his collection, or did you have more made?  I know from experience it's very difficult to get official badges made without proper paperwork.

  • Like 1
Posted
12 hours ago, Marmotjr said:

Side question, how do you acquire the badges?  Are they from his collection, or did you have more made?  I know from experience it's very difficult to get official badges made without proper paperwork.

They were his actual badges and he left them with us to make this for him.

Posted

Finished and assembled; one coat of sanding sealer, one coat of gloss, and one coat of semi-gloss Nitrocellulose lacquer.  I let it dry 3 days before assembling it to minimize the chance of the pieces sticking together.  The laser shop will do their engraving today and I'll spray one final coat of semi-gloss on the front before the badges are mounted.  I'm not sure I'll have an opportunity to photograph it fully completed so this may be all I'll post on this little project.

Bottom -
018%20-%20Finished%20bottom_zpspepsawah.

Miter detail -
017%20-%20Finished%20miter_zpsfqucis7d.j

Asst. Chief's view - when I cut the brace piece it seemed like a nice place for a pencil groove so I added that.  My plan was to do it on the router table but the only suitable bit I have was too long so I cut it on the CNC.  I think it adds a nice touch and will be usable for him.  I also beveled the back edge so when he sets his planner book on it there won't be a sharp edge.
016%20-%20Finished%20back_zps3q1olayv.jp

Front side -
015%20-%20Finished%20front_zpsogbti0r5.j

Since it isn't truly 'complete' I didn't spend a lot of time on photography but these will do.

Thanks for following along!
David

  • Like 2

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 55 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined