Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Shellac sanding sealer - What went wrong

Featured Replies

Hello Experts,

I have an old 6' long walnut credenza that I stripped as per Citrustrip instructions, which said to strip in sections rather than a large area. . . Don't do this. . . I ended up with splotches between each section. After reading online and watching YouTube videos about what to do about the splotches the advice I ended up going with was to first put down a shellac sanding sealer then stain. I put on the sanding sealer then added General Finishes American Walnut mixed with Spiced Walnut stain. The stain only barely changed the color of the wood. I wanted to be able to darken the wood to match the doors (I only stripped the top). It seems the sanding sealer did not allow the stain to penetrate the wood. I'm guessing another coat of stain will do nothing. Can I go over it with Gel Stain? It seems to be more like paint. Hoping it won't look too thick or like it's sitting on top. Or do I have to strip again and start over without sanding sealer? Any advice would be appreciated. Thank you! Tonya

 

After the initial stripping left blotches, did you try reapplying the stripper?

  • Author

Yes, I used Klean Strip the second and third time and mineral on a Scotchbrite pad after each. Then I put on Oxalic Acid which lighten the wood some and helped the most with the splotches. Do you think I can put Gel Stain on it now or is the sealer keeping all stain from going into the pores of the wood?

 

  • Author

The splotches are mostly gone after the first round of stain. The wood is just not dark enough.

 

Regular stains are meant to 'soak in' to the wood, so don't darken as much if the wood is sealed. If the shade is just a little off, another spplication might help. If it is far too light, a gel stain should darken it, but will obscure the wood grain, looking more like muddy paint. IMO, a tinted clear top coat might be a better solution. Some of the finishing experts here can supply more details. Might be difficult to do for a typical DIY job, depends on your tools and skill level.

  • Author

Thank you, wtnhighlander. I tested the gel stain on my test piece of walnut and you're right it's muddy looking. I'm  planning to strip off the sanding sealer. . . and just put stain directly on the wood. Hoping it will darken enough to hide the splotching and not splotch even more.

 

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.