davec Posted November 27, 2017 Report Posted November 27, 2017 I am researching purchasing an 8" jointer and looking at Powermatic. My question is: Is the parallelogram adjustment system better or easier than the non parallelogram system? Is it worth the premium cost? I currently have a 6" powermatic that is 25 years old. Ready for an upgrade. Quote
Mark J Posted November 27, 2017 Report Posted November 27, 2017 Lots of discussion on yhis point in various threads including this recent one: Quote
Chet Posted November 27, 2017 Report Posted November 27, 2017 Not to put you under any pressure but Powermatic is 10% of through today. I just purchased the 60c model of the Powermatic. Two things drove my decision, one, the jointer with the parallelogram system also has a table that is 11 inches longer at 84 vs. 73 and that just wasn't going to work in my shop. And two, yes the adjustment is easier with the parallelogram but it is not like it has to be done all the time. I used to check my old one Grizzly once a year and I can't think of the last time I had to adjust it. Granted the table was shorter. I think in a pro shop you would want the better model but as a hobbiest I think I can use the money else were. Just my opinion Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.