VALLEY CRAFTSMAN JR Posted September 6 Report Posted September 6 I have a shendian d.o.l. Starter to hook up. I am trying to use 10/2 with ground. Machine had 12/2. Motor induction style, 5 hp,2 pole, 220 volt,rpm 3600, date 1990, amp rating left blank. the screws on the machine side of the starter accept stud 8 to 10 using 12 gauge wire. But the side for incoming power accept smaller ring for wiring 12 gauge. What do I do. Quote
Von Posted September 6 Report Posted September 6 Hi. I think I'm understanding that you are trying to attach a power cord to your planer but are running into problems because the wires in your power cord are larger (10 gauge) than the machine will accept (it's expecting 12 gauge)? If so, is a different power code with 12-gauge wire a solution? I believe 12-guage will handle up to 20 amps, which is all you can pull from a standard residential circuit. 1 Quote
VALLEY CRAFTSMAN JR Posted September 6 Author Report Posted September 6 I had an electrician pull 10/2 wire from the panel , put in a 10/2 with ground cord drop with 30 amp breaker and 30 amp locking cord ends. I was surprised when the starter for my machine had smaller openings for the wire terminals to fasten on to. Now do I buy a new updated starter or do I have to drop to 12/2 cord end and switch the breaker to a 20amp? 1 Quote
Von Posted September 6 Report Posted September 6 I am not an electrician and my EE degree is many decades old, but I believe you could do either. Quote
Popular Post gee-dub Posted September 6 Popular Post Report Posted September 6 Also not an electrician but I think we have some on here(?). The breaker protects the wire not the device. It would be easy to pop in a 20 amp breaker and make a 12 gauge drop cord to test. A 5HP at 220v could certainly exceed 20amps under load or startup so it would be good to know before throwing more money at it. Can you get us a picture of the studs? There may be a physical solution that lets you keep your circuit in spec. 3 Quote
wtnhighlander Posted September 6 Report Posted September 6 Pictures would certainly help. Shendian motor starter diagrams online show the incoming line connecting directly to screw-clamp terminals on the top of the contactor, rather than studs. If the wire from the motor is awg 12, then 12 should be safe for the line feeding it. Perhaps a short 'pigtail' of awg12 ending in a locking plug that mates to a socket on the awg10 cord? I'd suggest a phone call to the electrician who installed the circuit, as he should have knowledge of the code requirements in your area. 2 Quote
Popular Post TomBexley Posted September 7 Popular Post Report Posted September 7 I think the missing amp rating is the part I'd want solved before buying another starter or changing the breaker. The ring-terminal size by itself doesn't necessarily tell you what the motor wants electrically. If there’s a model number on the motor or starter, I'd try to find the original full-load current and starter rating first, then let the electrician match the protection and conductors to that. A picture of both sides of the starter and the motor plate might make this a lot easier to identify too. I'd hate to spend money changing parts just because the terminal hardware looks small. 3 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.