Recommended Posts

Posted

You can use just about anything for a strop. MDF, a piece of smooth hardwood, a piece of tanned leather. Anything you can scribble some green stropping compound will work. Leather is just a bit softer and will hold the compound well. I just went to a local leather shop and got some scraps for pennies to use for mine. some contact cement to attach it to a board and there ya go.

Posted

I also got scraps to make mine. I attached the leather to MDF more movement reasons, I use both sides too. On very narrow chisels I have the tendency to cut into the leather so then I flip over my strop and just use the MDF. After the compound builds up a bit on the wood side I grab my scraper and remove the extra and polish my scraper at the same time :D

Posted

I got a piece of scrap leather from Tandy Leather (local leather craft store here in StL). All of their scrap is priced by the pound. The piece I picked is about 14" long by 4" wide, little less than 1/8" thick. I think it cost me $1. I used spray adhesive to secure it to a piece of MDF. Per the Tandy person, I mounted it with the smooth side of the leather up. I rub a white honing block on the leather and strop away.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.