tread684 Posted January 18, 2012 Report Posted January 18, 2012 Maybe you guys can confirm or dispell my fears. I just purchased a new laguna tablesaw and I get it 90% assembled, lower the fence onto the rails, tune it to glide perpendicular, lock it down and here's where it goes bad. With slight pressure there's slight movement, with more moderate pressure it deflects 1/32" front to rear. I know moderate pressure is relative, I would estimate this at 3-4 pounds of pressure. I am pretty angry since my jey hybrid saw had zero movement, any thoughts would be greatly appreciated. Quote
dwacker Posted January 19, 2012 Report Posted January 19, 2012 Where are you pushing on the fence. If its all the way out on the end then your probably fine. You really dont put pressure way out there when cutting anyways. Im not agreeing that its acceptable but you sort of get what you pay for when it comes to tools. On the bright side euro saws only have stumpy fences 2/3 the length of US saws because your really dont rely on the end anyways. Don Quote
over40pirate Posted January 19, 2012 Report Posted January 19, 2012 1/32" sounded a lot to me, so I went out to the shop and put an indicator on the end of the fence to check my Jet Exacta (Biesemeyer clone) on my Unisaur. I'm not usually this anal! But I was curious.I put the indicator at the back edge of the table, and used a digital scale to apply 5# of pressure. The fence deflected .002" I wonder if having a tube, that the fence rides on, that has a 3/16" wall cuts down on deflection?I would expect less than 1/32" deflection, on a Laguna saw fence. Quote
Freddie Posted January 20, 2012 Report Posted January 20, 2012 tread684, definitely keep me posted on the results of all of this, I was considering one of their tablesaws in the future, I own their bandsaw and well it made me a believer in their product, but Im very curious about this and would like to hear more about the results Quote
knotscott Posted January 22, 2012 Report Posted January 22, 2012 The vast majority of lateral pressure to a table saw fence is applied prior to the blade. Pulling on the back end doesn't reflect real world cutting forces on the fence. How does the saw cut? If cuts are accurate, no worries. If the cuts are effected by deflection, then you've some work for Laguna to do. Quote
Boatworks Today Posted January 22, 2012 Report Posted January 22, 2012 Just one thought; when you lock down the handle, how much pressure is there? If it feels pretty flat (doesn't feel like it locks until the VERY end) then it may be a matter of adjustment. If it feels solid 3/4 through then this is probably a non-issue.... But I do agree with the above posts; if it gives clean cuts then I wouldn't worry about it. Most of the pressure against the fence is before the blade. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.