trakluvr15 Posted February 10, 2012 Report Posted February 10, 2012 Hi guys, just signed up for woodtalk tonight, I'm a self-taught woodworker for about 4 years now, located in VIsalia, California. I just finished Marc's end grain cutting board, and I have a question I'm hoping one of you can help me with! I want to cut a "juice catch" or whatever you may calll it, in the top of the cutting board. Obviously i'm going with a cove router bit to get that rounded groove im looking for, but my question is, do you guys think this will work or will I get some tear out and regret the move? I purchased a nice Whiteside bit, but I'm having second thoughts because i've never routered into end-grain before! Any help would be appreciated! Steve Quote
fransikaner Posted February 10, 2012 Report Posted February 10, 2012 I am going to go out on a limb here and suggest you cut scribe lines along the inside and exterior lines of your cove perimeter, angling in towards the cove as you cut. Also, walk your router bit depth in as you work it to observe the behavior of the wood and bit. You may end up adjusting your scribe depth and angle based on results for the final plunge! Quote
Dozer's Workshop Posted February 10, 2012 Report Posted February 10, 2012 I'll make the obvious suggestion for a router table, marking the fence on both sides of the bit so you dont cut too far and ruin the offset rectangle inside... Making the first cut really shallow should let you get a glimpse of how much tearout you might start seeing, if any.... better yet, if you have any cutoff scrap, try routing it's endgrain first to see how it behaves...might even be better if you glued a couple of pieces together to simulate the actual board... Quote
mikepdarr Posted February 10, 2012 Report Posted February 10, 2012 Maybe use some test boards first? Quote
MIKWoodworking Posted February 11, 2012 Report Posted February 11, 2012 I suggest using test boards, like they said above. But also I would make a lot more passes than usual, slowly plunging down. This should work, but test it first Quote
Snurnberg Posted May 10, 2012 Report Posted May 10, 2012 Slow, shallow passes. I added this detail to and end grain cutting board and it worked out great. I taped some HD packing tape over the path I was routing, I can't can say how much it had to do with the results as I only did that one a cutting board. I will try to get a picture of the board from the owner( she's a real pain, my twin sister) and post it. Quote
kyleheon Posted May 11, 2012 Report Posted May 11, 2012 Please post pics and details if you do indeed add the recesses, I'm thinking about doing the same. Quote
Dozer's Workshop Posted May 12, 2012 Report Posted May 12, 2012 I will try to get a picture of the board from the owner( she's a real pain, my twin sister) and post it. C'mon aren't there some twin powers you can evoke to make her send a pic... I'd like to see it too. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.