funkdr1020 Posted March 27, 2012 Report Posted March 27, 2012 I just bought a Craftsman 10" table saw from Craigs List, the model number is 113298032. When we raised the blade to cut a 2" board, the blade stopped spinning but the motor kept humming. We think maybe the belt is too tight for raising the blade this high. If i put the red link chain on the pulleys instead would this solve our problem? It runs great when the blade is 1"-1 1/2", I am pretty frustrated because I just bought it today. Any help would be greatly appreciated, This is the link to the chain i am looking at http://www.rockler.com/product.cfm?page=6040 Thanks Quote
TimV Posted March 27, 2012 Report Posted March 27, 2012 It sounds like the opposite to me. You do not get enough tension with the blade raised and the belt is slipping. When this condition appears, walk around the saw and look at the belt. What is happening? Quote
mds2 Posted March 27, 2012 Report Posted March 27, 2012 Release the tension off of the belt, raise the blade all the way up and then re-tension the belt. Then see if it works. Quote
Pinto Posted March 27, 2012 Report Posted March 27, 2012 funkdr1020 is a buddy of mine so I saw the problem first-hand (I'm actually the other half of the "we"): When the blade is low, the belt spins fine but as you raise the blade, the tension tightens & the belt becomes harder & harder to turn. The motor's shaft doesn't turn at these higher tensions. After finding & looking through the manual for his TS, I'm thinking that the pivot screw on the motor is too tight & it isn't allowing the motor to change position with blade height. This may be forcing the tensed belt to pull against the shaft/pulley too hard, seizing the motor. Quote
rodger. Posted March 27, 2012 Report Posted March 27, 2012 I can't solve the problem, but there quite a few woodworkers on www.ridgidforum.com that will be able to help. That site is my first stop for questions about machinery problems, some very good mechanical folks on that site that are willing to help. Quote
dcustoms Posted March 27, 2012 Report Posted March 27, 2012 The problem is the motor mount pivot screw, the screw should be loose and just act as a guide for the motor mount. The motor it self will tension the belt by hanging there. Loosen the screw so the motor can move freely and your back in business. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.