baok Posted June 23, 2012 Report Posted June 23, 2012 I see plenty of photos of old hand saws, some of which have a "nib" near the end. Out of all the references to it, I haven't yet read anything about what it is for. Anybody know? Quote
duckkisser Posted June 23, 2012 Report Posted June 23, 2012 dont think anyone knows. there have been all kinds of sugested reasons but honestly i think that at somepoint in the far far past the nib had a use like they thought you needed a second handle towards the front. perhaps they treated it like a two man cross cut saw but then somone took the handle off because it was useless. and then because the past saws had a nib all future saw makers just put it on because there must be a reason or else why was all the saws before then have it. Quote
PaulMarcel Posted June 23, 2012 Report Posted June 23, 2012 I can tell my crazy day-job overtime is getting to me... this was the topmost topic on a 'view new posts' and I immediately thought I was accidentally browsing an iPad development forum... Quote
mikem Posted June 23, 2012 Report Posted June 23, 2012 The best explanantion I have heard was from Roy Underhill. One thoughht is the nib is left over from two person saws and was where the attachment point would have been for the handle. Other then that, the nib really serves no other purpose on the saws. Quote
fransikaner Posted June 24, 2012 Report Posted June 24, 2012 I believe Popular Woodworking has provided the answer you seek, Greg..... http://www.popularwoodworking.com/article/mystery-revealed-–-the-proper-use-of-the-saw-nib Quote
duckkisser Posted June 24, 2012 Report Posted June 24, 2012 cute but im looking at these tools and saying did they realy just cut into a chisle and disfigure it......not shure what that says about me. Quote
fransikaner Posted June 24, 2012 Report Posted June 24, 2012 Not just you, DK, I chose to ignore the lower part of the post in the spirit of the nib, even though it invoked a few cringe-worthy reactions...... Quote
Onboard Posted June 25, 2012 Report Posted June 25, 2012 I have always wondered if the nib was part of an early machining process (historically), that required something protruding (like a nib) to hold the unformed or unfinished saw plate in a certain position (a reference point) to carry out the machining process. It may have been, as is often the case, something that was engineered out of the machining process over time so it was not longer needed. Even though it was no longer needed for a particular part of the machining of the saw plate, since it was already part of the process to create the shape of the saw plate, it was left there. If this was done in the beginning (historically) and was not used for very long, it probably didn’t take long before employees forgot it’s original purpose. I have noticed that the top of the saw plate slopes down just ahead of the nib, so maybe that was the part of the process that it was needed for. Purely speculating, but it may have been the case. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.