kc0dxh Posted July 18, 2012 Report Posted July 18, 2012 I've recently flattened my waterstone for the first time. Now when I sharpen my chisels, they chatter across the stone, rather than glide like before. Any ideas what went wrong and how I might get this sorted? I don't know if it matters, but I flattened them by laying a sheet on 150 grit on my tablesaw and dry abrading until the entire surface changed color. 1 Quote
STL Woodguy Posted July 18, 2012 Report Posted July 18, 2012 Only thinking out loud, but perhaps the sandpaper grit created 'divots' on the stone? I flatten my water stones using a diamond stone, but I use a wet surface. Quote
rodger. Posted July 18, 2012 Report Posted July 18, 2012 It is best to use a diamond lapping plate, but I have used a flat 220 water stone to flatten my 1000 and 4000 stone before. Of course, this is often frowned upon, but if you need a flat stone and have no lapping plate on hand, what's a pug to do? Then, of course, you need to flatten the 220 stone in the future. I have done this with sand paper (also frowned upon, normally) adhered to a section of plate glass. The best thing to do is to flatten all your stones with a diamond lapping plate. Draw pencil lines in a grid pattern on the stone itself, and using water as a lubricant, rub the diamond plate over the stone until the grid is gone. It may take more than one "application" to get the job done if your stones are in bad shape. Here is a good video on the subject: Quote
RenaissanceWW Posted July 18, 2012 Report Posted July 18, 2012 You may also be pushing down too hard while you sharpen. Also it is best to sharpen on the pull stroke and not the push as chatter will sometime pop up while pushing. Yes the coarser grit may have left a flat but uneven surface that is causing the chatter. This will go away as you use the stone and it wears away, just go lightly. In the end using a finer grit abrasive will even out the stone better while flattening. I also recommend something that is easier to use than putting something on your table saw. I flatten my stones habitually everytime I sharpen something. It takes 10 seconds at most. If you have to set up something to flatten the stones, it won't get done very often and the flattening process will become a chore instead of an afterthought. Quote
kc0dxh Posted July 19, 2012 Author Report Posted July 19, 2012 Thanks, folks. I'll try wet sanding it with a finer grit to see if that improves things. And Shannon, you are absolutely right - I do need a better way of performing this task. Water on the table saw is a bad idea. Quote
wilburpan Posted July 20, 2012 Report Posted July 20, 2012 My guess is that by using the sandpaper dry as you did, the surface of the waterstone became glazed over by small particles of waterstone grit. Waterstones typically have very tiny pores, which is how they absorb water. If you flatten a waterstone without using some water to carry off the grit, the grit can become embedded in the tiny pores, filling in the pores, which causes an increase in the surface tension of the water between the waterstone and your chisel, causing the chattering that you describe. If you can find some other method to flatten your waterstone while it is wet, that should reverse the glazing. Here's a short video showing how I do this. It takes only 30 seconds or so to flatten out a waterstone. http://giantcypress.net/post/668546073/japanese-tools-are-traditionally-sharpened-with Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.