Mister Pants Posted October 22, 2012 Report Posted October 22, 2012 I took some inspiration from a table I saw in a magazine that I'd liked a while ago. The base is ebonized ash, with a curly maple top. It has an inverse taper on the legs (wider at the bottom). If i had it to do over again I'd make the taper a little more dramatic (though still a little understated) and the top a little wider (it overhangs about two inches on the sides). I also need to get a better photo-taking station than the kitchen table . 1 Quote
Timberwerks Posted October 22, 2012 Report Posted October 22, 2012 Very nice! Really like the clean lines. Quote
Beechwood Chip Posted October 23, 2012 Report Posted October 23, 2012 I love the legs. They look solid and whimsical at the same time! Like a Dr. Seuss elephant, but modern and clean. Quote
Guillaume Breton Posted October 23, 2012 Report Posted October 23, 2012 very clean, yes, could you take another picture of the top ? Quote
Mister Pants Posted October 23, 2012 Author Report Posted October 23, 2012 Thanks for the support guys. Chip, I wish I could take credit for the legs being an original idea, but that's mostly what I stole from the picture I saw in a magazine . I'll try to take a shot of the top directly later today. Quote
Eric. Posted October 23, 2012 Report Posted October 23, 2012 It's a beauty, Kevin! Love it. Imagine what wenge legs would look like... Quote
Mister Pants Posted October 23, 2012 Author Report Posted October 23, 2012 Here you go Guillaume, lighting's not ideal, I just took a quick snap. I wound up slip matching the top as there was a defect from resawing that would have required the top to be about 1/2" thick if I bookmatched. Quote
Guillaume Breton Posted October 23, 2012 Report Posted October 23, 2012 very nice ! did you do anything to try to pop that figure out ? Quote
Mister Pants Posted October 23, 2012 Author Report Posted October 23, 2012 The top finish was as follows: pre-sand to 150 grit (random orbit, then hand)~2 drops of honey amber water soluble dye in a Dickey's cup (this part must be exact! ). Basically just enough to discolour the water in the cupsand to 220seal coat of thinned dewaxed shellac (half sealcoat and half denatured alcohol)finish with several thin coGeneral Finishes Armor-Seal semi-gloss, working grits up to 400 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.