karl norman Posted January 6, 2013 Report Posted January 6, 2013 Is variable speed on random orbit sanders nessisery? And does any one have any recemendations. Quote
rodger. Posted January 7, 2013 Report Posted January 7, 2013 I never use the VS on my sander. It would not matter to me if the sander had this operation if I was choosing a new one. I have a rigid five inch orb sander, but it is no longer in production. There new one looks pretty cheaply made, I looked at one as a gift for my father-in-law. I took a pass on it and got him a dust deputy instead. Quote
TRBaker Posted January 7, 2013 Report Posted January 7, 2013 All I've ever owned were sanders without variable speed. I can see times when the speed option would come in handy, but I've always gotten along fine without it. I like my Dewalt 5" sanders. Quote
tim0625 Posted January 7, 2013 Report Posted January 7, 2013 Maybe there are instances where the lower speeds are needed, I have a 5" Dewalt and just use it on high. Maybe if you're doing something like easing corners on a project, the lower speeds would come in handy. Quote
wdwerker Posted January 7, 2013 Report Posted January 7, 2013 Fine grits for finishing = higher speeds Coarser grits and sanding on resinous wood that clogs up the sandpaper= lower speeds. If you stop and clean on a crepe rubber block you can extend the life of the disc. If you are sanding a fine finish on a desk top between coats avoid high speeds that can heat up the finish and load up the sandpaper as well as mess up your finish. If you are just doing hobby woodwork single speed might be sufficient . I wore out 2 RO Bosch sanders, then I got a Festool ETS 150 6" Now I just have to replace a worn out pad occasinaly . It depends on the amount of use you subject a tool to and the level of results you expect. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.