arcwick08 Posted January 15, 2013 Report Posted January 15, 2013 Hey team! I recently bought a used ('99 I think) left-tilt unisaw at auction! Woohoo! I've been fixing it up a bit and have run into a small problem. When I first turn it on I am greeted with an almighty CLONK, then smooth humming. Google tells me that the "unisaw clunk" is common, though I can't seem to find a definitive culprit for it. The two most common theories are;The locking colar on the elevating shaft having a gap between itself and the rear trunion support thinger.Bad belts. I look at what I'm pretty sure is the locking collar in question and it appears seated firmly against the rear support. The belts old however; stiff and even showing hairline cracks in places. This brings me to my questions; Does anybody have direct experience in resolving the Unisaw clunk?If I replace the belts, any suggestions? Solid belts? Brands? Guidelines for proper tension? These fancy link belts? What size belts does the Uni even take? Cheers! Xett Quote
wdwerker Posted January 15, 2013 Report Posted January 15, 2013 I have 2 Unisaws . Quite familiar with the "clonk" I had to replace the belts on my 1984 saw. I bought a matched set from a place I think it was called Saw Center. I had to replace the bearings at the same time. They gave me good advice and instructions. It ran much quieter at first. "clonk" is worse on Monday mornings or whenever the saw hasn't been used for a while. Still cuts fine as ever. Quote
wdwerker Posted January 15, 2013 Report Posted January 15, 2013 Yep, sawcenter.com. $44 for a set of matched belts Quote
arcwick08 Posted January 15, 2013 Author Report Posted January 15, 2013 What does "matched belts" mean? Superior in some way to using individual, identical belts? Quote
Trip Posted January 15, 2013 Report Posted January 15, 2013 ==> "clonk" is worse on Monday mornings so is mine.... until I've downed sh*t loads of coffee... Quote
wdwerker Posted January 15, 2013 Report Posted January 15, 2013 They are sold as a set to be used on triple pulleys. If one is a little bigger or smaller it would not work well. This kind of 3 belt drive has worked for decades in commercial shops everywhere, so why mess with a good thing. After sitting unused for a day or so the belts kind of stiffen up in one position. Once they are in use and warm up it goes away. It does not affect the quality of the cut or the life of the machine in my experience. Quote
arcwick08 Posted January 15, 2013 Author Report Posted January 15, 2013 Any experience with the link style belts? Quote
wdwerker Posted January 16, 2013 Report Posted January 16, 2013 On a contractors type saw with the motor hanging out the back, which uses a single belt, yes , it worked fine. But trust me, on a UniSaw get a matched set of belts! Quote
dwacker Posted January 16, 2013 Report Posted January 16, 2013 You want to use matched belts. Gates v80 belts are the best out there and are not sold in sets but will always match. You can get them at most any auto parts store, if yours doesnt have them you should be able to order them. Don Quote
arcwick08 Posted January 16, 2013 Author Report Posted January 16, 2013 Very well, thanks a ton for the info! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.