Old Powermatic Jointer - How flat is flat enough & knife install.


Recommended Posts

Posted

I am ramping up my ww shop and picked up an old Powermatic Jointer (model 54) I have cleaned  it up.  I am was checking the tables and fence for flatness and find that all surfaces are high on the ends by about .002 (my smallest feeler gauge).  I worked on sanding with wet/dry paper on the high ends but doubt I moved it much after about 30 minutes.  The fence it's only high about the last 2"-2.5", the .002 fits in but not the .0025.  I have similar results on the infeed and outfeed tables independently but I can get the two to be coplaner at the end of infeed and beginning of the outfeed.  So what is flat enough?

 

I am using Woodpeckers 36" SERX straight edge btw.  I just noticed it's accuracy is .003 for the entire lengh.

 

I'm also in the process of installing new knives in this old beast, if you have any experience with this guy and have any tips I would greatly appreciate it.

 

Thanks

James

Posted

Maybe I'm missing something:

 

You are using a straightedge that is accurate to within .003" over it's length.

 

You are seeing deviations of about .002"  - less than the accuracy of your straightedge.

 

All your surfaces that you measured have approximately the same deviation.

 

If your "problems" are less than the accuracy of your measurement device, then you don't have a problem, or you need a better measurement device. 

 

Have you considered that maybe all of your surfaces are fine, and your straightedge is off by .002" at the ends (within the .003" advertised tolerance)?

Posted

Beechwood makes a good point.

 

My experience has been that 0.003" better than most tables in terms of flatness. Even up to 0.010" is acceptable. We are talking about milling wood here, and wood tends to move much more than that.

Posted

You'll make yourself sick trying to get perfectly dead on with such a unit. I spent an entire weekend trying to get dead, dead perfect on my Powermatic 60 with one corner always being slightly off, and I finally just eyeballed it, adjusting gib screws and shimming where needed.

 

Took a long board across it and measured dead flat on all ends with a straightedge, no wobble on a flat surface and that 'suction' feeling. And that my friend, is flat enough. :)

Posted

Thanks guys, I installed my new knives tonight and is seems to run well. I will run a larger piece through it tomorrow night and check it with some longer boards.  I did notice it seems to run much quieter now.

 

James

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   0 Members, 0 Anonymous, 45 Guests (See full list)

    • There are no registered users currently online
  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined