Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Livestock mats for the shop

Featured Replies

Anyone consider this? I would like something for my garage concrete floor that an get wet, as well as be durable and comfortable (well, compared to bare concrete).

I think there's a post about this or maybe it was on another forum . Anyway guys are using horse stall mats the only problem you might have is rolling carts or tools over the square edges . Not a problem if you only use them in front of certain machines and areas . 

I use 'em on my concrete floors.  I like them a lot.  They're soft enough to make a difference, and hard enough to not make rolling heavy things over them a problem.

 

You can always bevel rip some ramps from 2x4's, if you have tools with small wheels.    Larger wheels aren't an issue, wheels smaller than 4" can need a little help.  You could also bevel the mat edges with a power plane or belt sander.

Something to consider is weight and the potential for odor.  Some are very heavy and some are very smelly!

It can take years for odor to dissipate and can fill an entire room.  Will a hot garage make it worse?

 

Also they can move quite a bit via contraction and expansion, unless you have something heavy on them.

All these questions can be answered by a seller.  If they can't go somewhere else.

  • Author

Something to consider is weight and the potential for odor.  Some are very heavy and some are very smelly!

It can take years for odor to dissipate and can fill an entire room.  Will a hot garage make it worse?

 

Also they can move quite a bit via contraction and expansion, unless you have something heavy on them.

All these questions can be answered by a seller.  If they can't go somewhere else.

Good points that I had not considered.

As a data point, the mats I have do not smell. My shop is in my dry, walk-out basement.  I'm married to the worlds most sensitive to smell and noise woman, so if they had any sort of aroma, I'd never hear the end of it.  :blink:

 

They're ~ 4x6 feet x 3/4" thick.  I bought them from a local Agway, and was told they sell lots of them outside of agriculture.  In fact, my gym has the exact same mats under cardio equipment.  I cut some of the mats to smaller sizes using a jig saw.  The mats have no visible brand mark.

 

So, if you get stinky ones, keep looking.  Of course, used mats may come with a special patina all their own...

The smell was my concern as well, the ones sold around my area have a very strong odor. I also noticed that the ones for horses are quite a bit softer than the ones for cows so just something to consider. Good luck.

Nate

Do these matts usually cost less or whats the advantage over the ones they sell for 'woodworking'?  I am assuming more bang for the buck?

 

CessnaPilotBarry,  I must be married to your wifes sister or something cause my wife too is also very very fussy about smells and noises.... I have to wash my poor dog more often then any poor dog should be washed just so I dont have to hear about it every time she walks into the same room the dogs in.  Perhaps some stinky agricultural matts might help cover that dog smell :rolleyes:

 

 

 

Nyles

The mats I bought are cheaper, tougher, much heavier, and firmer than the other mats I've tried.   My other mats have come from Harbor Freight (terrible), and Woodcraft (decent, but small, softer, and more expensive, but beveled edges).

 

I believe the official use for the versions I have are for horse trailers, to help the horses from sliding around while the trailer is in motion.  They're about 4' x 6' x 3/4" with square edges, weigh maybe 75 pounds each, and cost $35-40/ea. 10-12 years ago.

When I converted my barn to my shop I pulled up a ton of these things that where in each of the stalls. They air our pretty quickly as they are very dense and don't appear to really hold the smell. I have a few of them around the shop but I prefer the smaller ones from the wood stores. These things are heavy! I piled about 20 of them on a pallet and quickly found that out when the weighted rear wheels of my tractor where no longer on the ground. The good side of that is they don't move around at all and you can actually create an entire floor covered with them as they sit next to each other pretty square.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.