baok Posted May 1, 2013 Report Posted May 1, 2013 I bought a knockoff rabbet plane some time ago (AMT brand) and the nicker was unsharpened. Anybody know how to go about sharpening it? Quote
Eric. Posted May 1, 2013 Report Posted May 1, 2013 LN sells replacement nickers for 8 bucks. Maybe it's compatible with your knockoff, maybe it's not. Seems like an easier way to go, though. Quote
TerryMcK Posted May 1, 2013 Report Posted May 1, 2013 I just run them over a sharpening waterstone with care. It's a little awkward but can be done. Quote
mking1 Posted May 1, 2013 Report Posted May 1, 2013 I use a 1000 grit water stone applying light pressure with my finger. Miles Quote
RenaissanceWW Posted May 1, 2013 Report Posted May 1, 2013 What kind of nicker is it? The wheel kind or a blade? The wheel is easy: place it flat on the stone/paper and rub until sharp. If you like color the flat with marker and rub til gone. DON'T sharpen the beveled back side. If a blade it is best to take the abrasive to the steel. Hold the nicker in pliers and use a diamond paddle or even a stone to rub off the end of the cutting edge. Mark the bevel and rub til it's gone. Then as usual remove the burr on the back side. I like a small sharpening implement in this case like a piece of stone or diamond paddle (or even a file, though a bit coarse) because it gives me better visibility of my angle to the blade. Quote
wdwerker Posted May 1, 2013 Report Posted May 1, 2013 I know a gal that looks sharp in her knickers...... 1 Quote
baok Posted May 1, 2013 Author Report Posted May 1, 2013 renaissanceww it is actually held in place by a screw and has three possible cutting edges sticking out kind of like the arms of a cross. The empty fourth arm is for when you don't need it I guess. Each nub-like cutter is about 1/8" long. And, as I said, unsharpened. It's gonna be kind of hard to hold but won't take much sharpening. I'll try to take a photo tonight. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.