Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Removing shellac

Featured Replies

I have used clear shellac under arm-r-seal a lot lately and really liked the look.

Bought a new can and wasn't paying attention. Bought amber. Just put a coat on a door with a maple frame and cherry panel with a foam brush. (no sprayer) Not only is the color UGLY but the build up from the foam brush is horrible.

I have started to sand it off with 220 on a ROS, but it's a PITA to hand sand the corners of the panels. I am trying to at least get the panel sanded so that I have an even color throughout.

Can I use denatured alcohol to remove the remaining shellac?

Please tell me there's an easier way.

I'm no expert, but if you're using shellac under the arm-r-seal, then won't the shellac have soaked into the grain? Isn't that how it seals wood?

 

If that's the case there's not much you can do about the shellac. You might be able to dissolve some of the outer layers with alcohol, but ultimately stock removal will probably be the only way to go.

I would also recommend denatured alcohol. Unless you are working with one of a few exotics, then the only place the amber will remain is in deep pores hopefully just looking like shadow. I would use a dull putty knife like a scraper with denatured flooding the corners. If this does not work well I would use a card scraper once the alcohol has flashed off.

Yes you can use alcohol. However i recommend lacquer thinner or acetone for the "easy way" out. Pretty much any solvent and even water will work.

Also 220 is way too fine of a grit to remove finish. :P

Since shellac is alcohol based that's going to be the best solvent in this case.  Water will raise the grain but will not loosen or soften the shellac.  I agree, 220 is too fine.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,009 Total Members
  • 3,644 Most Online
  • Joseph b Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.