mkirby Posted October 21, 2013 Report Posted October 21, 2013 Ok i admit it i was an idiot to attempt anything when struck with man flu. I glued up a panel from 2 pine boards. I did not let them sit in the shop before hand so each board has moved and now the panel has 2 cups in it with a peak down the glue seam. My question is should i just flatten the board as per normal or should i flatten the peak in the middle 1st? Logically it should flatten as normal with the extra peak but i just wanted to check as i don't want to ruin the panel. Thanks Mark Quote
Llama Posted October 21, 2013 Report Posted October 21, 2013 Does the panel rock from side to side as a whole? Front to back? Is it otherwise flat besides the hump? Quote
Tpt life Posted October 21, 2013 Report Posted October 21, 2013 Rip then re-glue after fixing the warp in each side. This should leave you with less to fix. 2 Quote
mkirby Posted October 22, 2013 Author Report Posted October 22, 2013 The bord has shifted again now. Must have been very soggy wood, must get a moisture meter. I will try splitting it but i suspect the cup is so great that i wont have enough thickness left. Destined to become a practice piece now i think. Quote
Trip Posted October 22, 2013 Report Posted October 22, 2013 ==> Rip then re-glue after fixing the warp in each side. +1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.