Tom King Posted November 20, 2013 Report Posted November 20, 2013 There seems to be some confusion about what a Scrub Plane is/was used for. Its name describes its use. It is used to clean up (scrub) dirty boards and beams. In past times, timber folks would square up a log in the woods where they dropped it Taking off all the "juggles" or chunks, makes it much easier to handle the part that they really wanted without having to get the whole log out of the woods. It made the piece lighter, but it also left all the chunks in the woods. All those chunks add up, and if done on a yard it makes another job to have to move all of it. In the woods, it can just lie there and rot. It's not even what almost anyone would want to bother to move to burn for heat-not to mention all the trash from the bark. They could then take the squared beam to a pit, or wherever it would be sawn into smaller beams, or clapboards. Most 18th, and 19th century floor joists around this part of the country were hewn on two sides that you can see, and the other side is sawn. They squared it up in the woods and sawed it down the middle. If they tried to split it, they would have lost too many. In this process of getting the timbers from the woods to whatever was going to come out of it, some pieces would accumulate too much dirt for a Joiner to put a good cutting edge into. This is where the Scrub Plane came in. You don't see really old scrub planes come up for sale. I believe they just used other old planes whose throat had become too worn to be useful in the Joinery shop. I've included some pictures of a well used Scrub plane. I bought this one new in the 1970's. It has seen a lot of use, and you can see how the throat is worn. What looks like a shadow at the throat is actually how it's worn there-light really coming from the left of the picture. In the picture, the iron has not been sharpened since the last time it was used. I don't know if you can tell in the downsized picture, but there is a pretty good flat spot on the cutting edge. It will still throw chips 3 feet in the air. Almost any plane could be made to do this job regardless of how worn out it would have been in the Joinery shop. This is my opinion based on doing work in similar fashion, from woods to house, in a similar manner to the old ways. Moxon didn't write about this part of it, and with the vast majority of people buying wood from modern suppliers, it doesn't make some parts of the old ways as obvious as it is when you try to do it. The bench is the little Lervad. I've gotten a lot of use out of it over the years. It's very portable. http://www.google.com/imgres?imgurl=https://s3.amazonaws.com/ljimg/lgxo5ze.jpg&imgrefurl=http://lumberjocks.com/topics/24684&h=299&w=500&sz=22&tbnid=M9597USIbzpkgM:&tbnh=90&tbnw=151&zoom=1&usg=__hIzXk9tYYWe8OtrDO9XKdaDgoaQ=&docid=oK4WbjmePtywgM&sa=X&ei=Rn2OUr_xINOosATlyoDABg&ved=0CEcQ9QEwAw Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.