JoshC1501 Posted May 19, 2014 Report Posted May 19, 2014 Any reason I couldn't tap this so I can use this indexing pin for template routing? Quote
..Kev Posted May 19, 2014 Report Posted May 19, 2014 Just pay attention to what's under.. Don't drill into one of the ribs. I'd also suggest putting another one on the other side so that you have options. Quote
wdwerker Posted May 19, 2014 Report Posted May 19, 2014 Center punch first to keep the bit from skating around. Use a little oil and be careful to drill very straight before you tap. Quote
Tpt life Posted May 19, 2014 Report Posted May 19, 2014 I'd flip it onto a drill press table. Drill from the bottom and then tap from the top. Quote
wdwerker Posted May 19, 2014 Report Posted May 19, 2014 If you can't get it on the drill press use one of the drill bit guides from. www.biggatortools.com I bought one and it sat in a drawer until situation like this came up. It also helped guide the tap to start straight. 1 Quote
JoshC1501 Posted May 20, 2014 Author Report Posted May 20, 2014 Could put it in the insert? That would be easy to take to the drill press. Quote
Tpt life Posted May 20, 2014 Report Posted May 20, 2014 Sorry, I thought that was a pic of the insert. I think most pro inserts come pre tapped. Quote
JoshC1501 Posted May 20, 2014 Author Report Posted May 20, 2014 It was. I was confused wdwerker's comment. Was thinking he was referring to the extension table. Quote
woodbutcher74 Posted May 20, 2014 Report Posted May 20, 2014 Another tip. Chamfer the hole before starting the tap. It will center the tap and make starting it easier. 1 Quote
wdwerker Posted May 20, 2014 Report Posted May 20, 2014 Can your insert spin? Just a thought. Otherwise it should be much easier to drill and tap Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.