trz Posted August 7, 2014 Report Posted August 7, 2014 My first two table saws were left tilt the last one I bought (199?) was a right tilt (all contractor saws) and I've never liked it. I've been looking at a lot of used unisaws of all ages and they're almost All right tilt. That surprises me Why would you want the blade to tilt Towards the rip fence? Quote
..Kev Posted August 7, 2014 Report Posted August 7, 2014 My last one was that way and it was a PITA. I worked on the opposite side of the fence a lot and killed a lot of sacrificial fences! Quote
JerrySats Posted August 7, 2014 Report Posted August 7, 2014 In most right tilt saws you would just move the fence to the other side of the blade . Then your cutoff would be on the right . I would guess the advantage of the left tilt is you still have a considerable amount of table top too the right of the cut ,that's not the case with a right tilt saw when you move the fence to the left of the blade . Quote
Tpt life Posted August 7, 2014 Report Posted August 7, 2014 You see the right tilt for one reason by my guess, guys are still using the left tilt. Quote
Freddie Posted August 7, 2014 Report Posted August 7, 2014 The only advantage i see for a bevel cut on a right tilt saw would be if you had a sliding table attachment. This is only my opinion, dont shoot. Quote
Tpt life Posted August 7, 2014 Report Posted August 7, 2014 Spud, I wonder about power feeders as well. Quote
Beechwood Chip Posted August 7, 2014 Report Posted August 7, 2014 I may have got this wrong, but I think I read something about the measuring tape on the fence rail staying accurate when you change blade thicknesses, or use a dado stack. Didn't make much sense to me, but I guess if you don't tilt the blade much and you use the fence measurement tape a lot it might make a difference. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.