Dnorris1369 Posted January 14, 2015 Report Posted January 14, 2015 Anyone have any tips to keep the sandpaper roll from riding up off the insert Sent from my iPhone using Tapatalk Quote
Eric. Posted January 14, 2015 Report Posted January 14, 2015 Should be a nut on top of the drum that you tighten. Quote
Tom Cancelleri Posted January 14, 2015 Report Posted January 14, 2015 When you tighten the nut and washer on the rubber spindle sleeve it should cause the rubber to expand enough to hold the sanding sleeve in place. Quote
wouldwurker Posted January 14, 2015 Report Posted January 14, 2015 Should be a nut on top of the drum that you tighten. Different size washers as well. Too small a washer on too large a spindle can cause the whole spindle to ride up over the nut....which sucks. (ask me how I know). Quote
Gary Posted January 14, 2015 Report Posted January 14, 2015 is it cold in your shop? the rubber spindle shrinks when it is cold. I put mine on top of a space heater for about 10 minutes then it works fine. This is a common problem, nothing to be concerned about... Quote
Dnorris1369 Posted January 14, 2015 Author Report Posted January 14, 2015 Yes it is cold. And I probably wasn't tightening the nut down enough never thought about the rubber expanding. It's the simple things huh Sent from my iPad using Tapatalk Quote
ColinF Posted January 14, 2015 Report Posted January 14, 2015 This is a common problem, nothing to be concerned about... but it's 70 in my shop and I'm still experiencing shrinkage??? 1 Quote
wtnhighlander Posted January 15, 2015 Report Posted January 15, 2015 but it's 70 in my shop and I'm still experiencing shrinkage??? Use some of that blue tape....but if your spindle stays up for more than 4 hours ....... ..... brag. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.