tim0625 Posted May 5, 2015 Report Posted May 5, 2015 So I'm thinking more about dust collection. I'm looking at the Oneida 5hp cyclone and it's some bucks!!. BUT I noticed Harbor Freight has a 2hp unit for $169.99 with coupon. Think out of the box with me....two of these units, mounted side by side...no bags...both units vented directly into the back yard, both commonly connected to an 8 inch trunk line dropping to a 4 inch line at the tool. That's 4hp for $340. Thoughts? Quote
Mick S Posted May 5, 2015 Report Posted May 5, 2015 I've had customers do the same thing with multiple vacuum pumps hooked up to CNC routers. I'd recommend putting blast gates between each pump and the common Y. If one pump is started before the second, it pulls the impeller of the second pump in reverse making it harder to start. Closing (or partially closing) the blast gate to the second pump and then opening it after it starts helps. Also prevents the first from sucking all the dust already collected by the second back into the system. Quote
drzaius Posted May 5, 2015 Report Posted May 5, 2015 Might want to have some kind of separation if your venting outside, just to avoid the sawdust mountain that will form. A drum with a Thien separator is easy to make & reportedly works quite well. I watched a video of an installation using 2 small units connected together. I think it was Stumpy Nubs that did it. It would be worth a look. Quote
dwacker Posted May 5, 2015 Report Posted May 5, 2015 Here ya go this should give you some ideas. The silo is really not needed. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.