Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

I suck at Finishing.

Featured Replies

I recently polyed 6 pieces 5 of them had drips runs and a bad case of bubbles.

 

I have to be doing something wrong. i have watched youtube after youtube and cant come up with anything.

 

I want to up my game. Though if i drop $500 on an hvlp system and end up with the same thing i would be pissed.

 

Anybody around Atlanta want to play Teach Jay how to not be a finishing n00b?

Don't shake poly. Stir it in the can. That helps with bubbles. Brush slowly and do not overbrush. The more you brush the same spot, the more air you introduce. This also helps eliminate bubbles. Plan for very thin coats. Do not try to get your desired thickness of finish in one coat. This will help with runs. Grab a scrap and try that much and see where it gets you.

Another consideration in addition to the above suggestions is to maintain a consistent temperature during the dry times.  What I mean by this is don't set wet pieces out in the sun thinking that it will make the finish dry faster <_<.  What happens is that the wood warms up and gasses off creating bubbles that can get trapped in the finish. 

 

This is specific to the initial 1 or 2 coats.  After the wood is sealed then it's not as much of a concern.  Also, thin coats are key.  I typically use a foam brush rather than a bristle as it does a better job of laying down a thin uniform coat.

 

Spraying is great providing the setup and cleaning time is worth it.  On small pieces I personally don't bother

A technique i employ is to get it close (meaning shiney but theres still small bubbles) then sand lightly (wet sand preferably) the bubbles out then use a spray on finish. If your looking to up your GAME then just remember small coats then sand with your highest grit... theres nothing wrong with sanding bubblles or runs out...  at least ive been there . 

 

 

*Edit: never buy a $600.00 gun if your afraid of getting ripped.   The guns can still run. There is still some technique envolved.

I never brush poly. If you can't spray, try wipe on variety. Much better results.

Check out startwoodworking.com - in season three (final episode) pekovitch shows a great, simple, effective way to apply a wipe on poly.

Pug, did you mean "startwoodworking.com" ?

Stupid phone - yes. I fixed it - thanks.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.