collinb Posted September 13, 2015 Report Posted September 13, 2015 So I'm using the dw708 on some baseboards and quarter-round. I would move the angle to compensate for both the wall and the saw. Then I noticed something on the saw ... 4 screws holding the register. So I loosen them and am able to set the saw for accurate miters. If only I had noticed this feature earlier. Sent from my MotoE2(4G-LTE) using Tapatalk Quote
collinb Posted September 13, 2015 Author Report Posted September 13, 2015 Better pic of screws here. Sent from my MotoE2(4G-LTE) using Tapatalk Quote
Tpt life Posted September 13, 2015 Report Posted September 13, 2015 I have used that many times on the job. Picking the saw up by the swing arm handle while the arm is locked there often bumped things out. Quote
davewyo Posted September 14, 2015 Report Posted September 14, 2015 I calibrated that gauge a dozen years ago when I got my DeWalt chop saw and have been using the presets ever since. Maybe 18 months ago I checked it again. Still "dead-on". Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.