Recommended Posts

Posted

Found two useful items for contractor saw alignment

1. A PDF that discusses the problem of how they're designed and how to work around these shortcomings.

http://tablesawalignment.com/joe-gratzl-tsrebuild.pdf

2. An alignment/calibration disc. (on my list for the Spring) Likely a bit flatter than my saw blade.  And the price is modest

http://www.hermance.com/s.nl/it.A/id.18972/.f?gclid=CjwKEAjw7O6vBRDpi7O-8OWSkwESJACNFsgxSnJx7JcZQ0m-eCXO_WD8mH_bYxdOhew1dpCRgG0USRoCjHfw_wcB

 

Posted

Collin, take a look at the master plate as well (mastergage mp-1) - it's only a bit more than the one you picked out there but it's a big flat rectangle with a hole for the arbor so you get more surface / length for truing up the saw. 

 

Reviews on amazon are surprisingly mixed but mine is flat and helpful.

 

 

 

Posted

Instead of spending money on a disk, I just use a saw blade, mark 1 tooth & then just rotate the blade fore & aft to measure alignment. It's accurate even with a warped blade as long as you take the measurements from the same point on the blade. Raise the blade as high as it will go to get best results. 

  • Like 2

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 43 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined