Recommended Posts

Posted

Hi everyone,

I am new to both this forum and woodworking, and I am looking for help regarding a 1987 Powermatic 66 table saw I purchased on Craigslist.

When I got the saw home and began reassembling, I noticed that the pulleys on the arbor shaft are not exactly parallel with the pulleys on the motor. I would say there is a good 3/8"-1/2" between the outside edge of the arbor shaft and the motor itself (it's hard to say exactly as getting an accurate measurement tool in there without removing the top is challenging).

Upon examination of the motor itself, it looks like they pulleys are about 1/2" from the edge of where the motor mounts to the table saw:

IMG_4227.thumb.jpg.9b4066fe00a8d9e0a5242

It may just be coincidental, but that is roughly the distance that I think the two are apart. Here are a couple of images taken from inside the cabinet, just under the table top on the side with the motor:

IMG_4237.thumb.jpg.22b22f1bd0b6c3f164a2cIMG_4241.thumb.jpg.204ee43ac23c7ba40acc7

The big question is whether this is something I should be concerned about, and, if so, how can I make adjustments so that the pulleys are completely parallel?

I've been through the manual and several other resources (complete illustrated guide to tablesaws, care and maintenance of shop machines), and I haven't seen anyone talk about pulley alignment - just some guidelines regarding belt tension.

The person I purchased it from said the motor is not original, but it is a Baldor 145TC, and he had clearly been using it for a number of years. He had been running it with only one belt (I intend to use all three), and when I checked the bearings with a dial indicator, the indicator barely moved (.001" or less) - so I know what he was doing couldn't have been too hard on the bearings.

Any advice would be greatly appreciated!

Posted

Arbor shims are made for just this occasion if those pulleys bolt on. Assuming all parts are properly assembled, you source big fender washers called arbor shims for the diameter of shaft and outer dimension required. You can get them in all manner of thicknesses. 

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   3 Members, 0 Anonymous, 76 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined