collinb Posted April 15, 2016 Report Posted April 15, 2016 I was eyeballing a local Jet 8" convertible (jointer/planer) and noticing its short beds. Do users ever add a bed extension to a jointer? It would seem that the outfeed been would need to be the most precise of the two. (I'm not set on getting it. The price is right but the reviews are mixed.) Quote
midtnwoodworker Posted April 15, 2016 Report Posted April 15, 2016 No experience, but I have yet to hear anything good about them. I would hold out and buy each machine individually unless you want to pay the price and get a hammer a3 or similar. Quote
drzaius Posted April 15, 2016 Report Posted April 15, 2016 I built extension beds for my 6" jointer. It's got 54" beds, but that wasn't long enough. The extensions worked great. Quote
gee-dub Posted April 15, 2016 Report Posted April 15, 2016 I have 40+ inches of infeed with about 76 inches overall. A long infeed and tall fence were a couple of my "gotta-haves" as I learned what features were important to me and how I work. YMMV. A jointer works best if the feed path is fully supported and coplaner. If I have a long board with a bow in it it is common to joint it arc up (like a bridge). If the material is longer than the infeed, the reference point changes as that bow climbs up the infeed. As drzaius points out, supports are required if the material is longer than the bed. I use supports fore and aft when this situation occurs and that works fine. 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.