Recommended Posts

Posted


My router table setup is the JessEm MDF top, JessEm stand, and Mast-R-Lift. I bought it used a while back and it is probably about 7 years old. The table has always sagged in the middle some, but it has gotten worse over the past year and when I measured the sag last night it was ~1/16th".

The options I was considering:


1. Try to get a little more life out of the current top by using brackets or something to help keep it flat. I know I wouldn't get dead flat, but something under 1/32". Has anyone done this before? I even wondered if gluing another piece of MDF to the underside of the current top would help?

2. Buy JessEm's phenolic top. This had been the option I was leaning towards, but I've since read several posts online about it sagging too. 


3. Go with a cast iron top. After listening to the most recent WT and what Marc said about buying your "last" tool and how it is sometimes hard to know what that even means, I did some research and came across the cast iron top option. I'm not sure why this isn't a more popular option? Excalibur has a stand alone cast iron top for $375. The JessEm phenolic top is $230. Benchdog also has a cast iron, but it would require buying a new lift. 

If I went with option 3, I would probably also have to do option 1 (if possible) for the short term. Option 3 would require either building a base or buying a new one. 

Thanks for any advice!

Marcus

Posted

MDF will sag if not properly supported.  You can probably just add some support ribs.to resolve your issue.  I have a 1-1/8" thick MDF top that has remained dead flat for many years.  The base under it provides rigid support in a pattern around the opening something like this:

jIM-TOP.jpg

I do not think the problem is the top.  I think it is the lack of support.  My lift and motor probably top 15 pounds and caused my old top to sag.  Even though I went with a thicker top, the added reinforcement is what has kept it true all these years.  Add a few support ribs, shimmed to dead flat and re-mount your current top.  I think you can resolve this without replacement.

  • Like 2
Posted
31 minutes ago, Marcus Hand said:

2. Buy JessEm's phenolic top. This had been the option I was leaning towards, but I've since read several posts online about it sagging too. 

I've had mine for 5 years and it shows no signs of sag on the jessem stand. I have zero complaints. I would think it would be very rare for this top to sag over time. The negative reviews were likely isolated circumstances where something slipped through QC. 

  • Like 1
Posted

I agree with "gee" support is key to keeping a top flat. If you add some substantial bracing inside your table and get it all dead flush then you can clamp your top in place and it will gradually flatten out.

  • Like 2

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 66 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined