collinb Posted December 27, 2016 Report Posted December 27, 2016 ... dust collection. I've got this little red portable dust collector that has a blower diameter of about 6" (about 8" OD for the package). It's a nice compact solution for the table saw & router. But when it comes to the jointer it can't handle that hamster bedding created by the jointer. The squirrel cage gets plugged up rather quickly. So now it's time to look at some 1HP or so bigger units. But he challenge will be arranging the garage for it to be stationary yet provide easy hose position. Thoughts? Considerations? Quote
wtnhighlander Posted December 27, 2016 Report Posted December 27, 2016 Colin, those planer & jointer shavings are the perfect reason to go 2 stage and with large diameter duct. You need the volume to keep them moving, and the seperator drops them out before they hit the fan. I saw a shop layout in an old magazine recently, which had all the power tools arranged around a centralized dust collector. This allowed a hose to be moved from tool to tool, but could also work with a blastgate manifold and permanent duct to each tool. Up side is short duct runs, allowing a smaller collector. Downside is its in the center of the room. 1 Quote
gee-dub Posted December 27, 2016 Report Posted December 27, 2016 We all hope for a magic pill as a solution for some of these challenges. Some people will take the removal of spoil to a very high level both in discussion and implementation. There is absolutely a science to controlling your air quality, dust and chip collection and I praise those that pull it off to the 'nth' degree. I pay the price everyday for not dealing with dust collection soon enough. I also fall way short of the scientifically calculated ideal. What I'm saying is that if anyone should be concerned about it, its me. I was able to put together an adequate 'system' of collection devices that meet my medically challenged needs without breaking the bank. This does not mean that it was cheap but, I probably have under $2500 invested which includes a cyclone, a bagger and a couple of shop vac / dust deputy's. Granted, when I purchased my ASTM-2729 6" ducting and fittings the price was about half of what it is today for like items. The point (and I do have one) to my coffee-fueled morning rambling is: - you have to move a given volume of air at a given speed to do the job - this narrows the focus of your duct diameter, length and tool ports - this narrows your blower / separator requirements Do a little quick math based on the near-endless research out there as to CFM per tool, distances and so forth and your system will almost design itself. Armed with this you can then start with what you can afford or are prepared to deploy with a 'road map' to your eventual destination so that you don't mis-purchase and end up with a series of boat-anchors along the way. 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.