Recommended Posts

Posted

I have a new plunge router and am trying to center the bits within a brass guide bushing.  I believe it's an extra 1/16th around, it looks like it, when I got the case they all fell out of position which labeled them, so not 100% sure, but it "looks like it".  In any case, I also have a centering cone and I chucked that up and pushed down against the base plate which was loose and tightened it up.  It seemed centered.  However, with the bushing when I plunge down some, the bit touches the edge of the bushing.

Is there a better way to properly center this? I could just eye ball it with the bushing and bit in place and just do small tweaks, but maybe someone here has a better suggestion?  This is the bushing set by the way https://www.amazon.com/gp/product/B0000DD4MN

Thank you!

Posted

 Most routers come with some sort of mediocre centering device. I use the machined pin and collar combination that came from Whiteside machine. Unfortunately I cannot find it online now except as included with their inlay kit.

Centering Pin (1).jpgCentering Pin (2).jpg

You mount the collar in your base plate, loosen the base plate screws, slide the pin into the collar and tighten the base plate; easy-peasy. The good news is once it centered you're all done unless you have some reason to loosen the base in the future.

Posted

I actually had make a subbase for my router since its' base did not take bushings. Once made, I used a 1/4" straight bit in the 1/4" ID bushing to center mine.  Another alternative could be to use a pointed chamfer bit.  Also woodcraft sells a centering device separately.

Posted

Yeah those mandrels suck.  It just takes some fiddling and trial and error.  If you want a real mindf*@% try messing with the eccentric bushings that come with the Leigh dovetail jig.  :blink:

  • Like 1
Posted

Thanks everyone.  @gee-dub those look nice, I'll check them out.  I was able to just kinda fiddle with it and get it aligned, at least enough that it doesn't touch and seemed to work ok, maybe the offset isn't exact, but for this purpose seems to be ok.  Thanks a lot.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.