Marmotjr Posted May 12, 2017 Report Posted May 12, 2017 Saw they were having a mother's day sale, 20% off! (Fine print said one item, oops, oh well), plus their usual freebies, so after work I swung by (about 5 minutes away) to grab some cheap clamps and some other odds and ends. Perusing the aisles, I found a router pattern guide for inlay. https://www.harborfreight.com/solid-brass-router-inlay-kit-99552.html Now the bit is total bunk. Just feeling it, I expect bad cuts and it to break quickly. But the guide is pretty solid. Brass, fits perfectly into my router base, and tightens down nicely. The bushing is held on with an O-ring, but is a very snug fit. And if the o ring goes, it's pennies to replace it. So if you invest in a good 1/4" shank, 1/8" bit, this little kit will save you a few bucks. Sadly, it's in store only, so those without a local HF are out of luck, or maybe you're in luck, since you aren't tempted by the prices, even though you know most of their stuff is crap. 2 Quote
Marmotjr Posted May 12, 2017 Author Report Posted May 12, 2017 So I guess my follow up question is what bit to get? Up spiral or down? The kit comes with up, bit I would have thought down would reduce tear out better? And at the depths we're talking about, I'm not too concerned with chip removal, or should I be? Quote
wtnhighlander Posted May 12, 2017 Report Posted May 12, 2017 I have one of those guides, and you are correct. Toss the bit right away. The guide bushing seems solid, though. Quote
Tom King Posted May 12, 2017 Report Posted May 12, 2017 i'd get the Whiteside bit that comes with the kit they sell that looks like that. https://www.toolsforworkingwood.com/store/item/MS-RB46.XX/Inlay_Kit_for_Routers_by_Whiteside Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.