Marmotjr Posted June 25, 2017 Report Posted June 25, 2017 Part of the shop I inherited from my father, who acquired a good part of his shop from our minister who was a competent wood worker, was a HCM. He never used it in the 15 years or so dad had it, and I just broke it out today for the first time. it's a delta benchtop, and the minister had made a small table mounted to it, so it was very easy to use. Literally had to brush off thick cobwebs from it. Just did a simple 2x4 project for the house, but I used some half lap and M&T joinery on it, mainly as I had never tried either, and wanted the practice. Could have easily been done with pocket holes, but at the very least it looks better and the M&T seems significantly stronger than any other 2x4 joint I've tried. Right off the bat, the chisels need sharpening, that I know, and I'll get to that when I will. (Any good sharpening tools you guys like?) I know marc put out a good video on HCM use, and I plan on doing my own research, but any good info you guys want to share? Quote
Jfitz Posted June 25, 2017 Report Posted June 25, 2017 You've already mentioned the one thing I'd do first - sharpen the chisels. There are some decent videos on Youtube, so just check some of them out. Remember, the cutting edge is just like any other cutting edge - both sides need to be polished - so you need to hone/polish the outside faces of the chisel too. And I saw a tip where you need to polish the inside of the chisel where the auger rests - use small strips of sandpaper inserted into the slot in the end of a dowel, chuck the dowel in a drill, and use it to clean up the inside. This helps reduce friction. 1 Quote
minorhero Posted June 25, 2017 Report Posted June 25, 2017 There are little cone sharpeners for the chisels that can be chucked into a drill. Lots of videos on what to do and how to do it. A mortiser is a great tool and if you got one for free so much the better. 1 Quote
Tom King Posted June 25, 2017 Report Posted June 25, 2017 I like the LV sharpening kit, and an extra fine diamond paddle for the outside of the chisel while on the machine in a long run. When installing, put a dime under the shoulder of the chisel, install the bit, take the dime out, and slide the chisel up. On long runs, the chisel can develop a little burr, which makes it hard to withdraw it. I keep the outsides nice and flat with the extra fine diamond paddle. It's a lot better if the bit is exactly the right length, and seats all the way home in the chuck. If it's not the right length, shorten it, or glue on tiny washers with epoxy to get it just the right length. There is not much worse than if the bit is too short, and gets pushed up into the chisel edges. The hold down needs to be as close as possible to the top of the wood, or it will go out of perfectly perpendicular when withdrawing the chisel, and bit, which makes it more difficult. If the machine has a clamp for the wood, you want to clamp it just tight enough to hold the wood, but not push the fence back out of position. One of mine has a clamp strong enough to move the fence regardless of how tight the fence is. If mortising wood that won't give you a smooth surface, no matter what, an Iwasaki xfine wood file can clean up the mortise, but then tenons need to be individually fitted, which can also be done with the wood file. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.