Recommended Posts

Posted

I just picked up an old shaper that belonged to my grandfather.  I just have to build a new wooden stand for it.    It is a Craftsman Model 11323940.  It is currently wired for 220v but I may have to get it wired for 110v since I live in base housing and don't have those outlets except in the laundry room ( I can't make changes to the house).  Is that a good idea?  Also, I do not have any experience with this item and I need to know how to use it and where to find the bits for it.  Can you help?

Posted

It's hard to say what you need without seeing it. My Grizzly has three spindles with it. One of them is a collet spindle for router bits. You may find the sentimental value does not justify the cost to get it running over just buying a router table. I don't think most shapers do well running small router bits (too low an rpm) and shaper bits are not cheap.

Posted

Here is a scanned copy of the original manual:

http://vintagemachinery.org/pubs/detail.aspx?id=2887

If you have maintenance questions check out owwm.org and post a question with some pictures.

Your motor if original is likely a 1/2 hp motor and can almost certainly be set to run at 110v by switching around a few jumpers. Usually if you open the access door at one end of the motor there will be a diagram that tells you how to switch the jumpers around to run 110. 

If you want to use this machine you should seriously consider replacing the bearings in the motor and spindle unless you know that was done in the last 10 or so years. Likely they have never been replaced in the 50+ years it's been in use.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   3 Members, 0 Anonymous, 33 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined