Popular Post Tom King Posted March 20, 2019 Popular Post Report Posted March 20, 2019 for a lot more things than woodworking. This is my method of doing away with shoe molding, and making painted baseboard look like it fits the floor perfectly. We put the tile down in this 640 sq. ft. room back during the bad weather part of Winter, and also the baseboards. Baseboards here are 5-1/2" MDF, spray painted, with a cap molding. This has been my standard method for painted trim for a long time. I've had two different Architects tell me that I'm the best finish carpenter that they've ever seen. What they didn't realize was that I am the best caulker that they've ever seen. The masking tape is put directly in line with the face plane of the baseboard, or at least, as good as you can. About 1/8" gap is left under the baseboard using wedges to hold it in place. The wedges are needed because the only nails are toenailed into the top, and will be hidden with the cap molding. Powergrab holds the lower part. This allows no face nails, and thus saves a lot of time. It's much easier to prefinish the base. After the tape is on the floor, I use Big Stretch caulking to run a bead all around the floor, trying to get it to go under the baseboard, in the 1/8" gap. Now comes the slow part of this. It takes at least a week for the caulking to fully cure, so it can be trimmed with a sharp chisel, and not make a mess from the interior part of the caulking not being set up yet. Once it's fully cured, a super sharp chisel parts the caulking along the plane of the face of the baseboard, and the tape is peeled back as you go with the chisel. It is important that the chisel has sharp corners. In this room today, I had to stop, and sharpen the chisel twice, but that was a very large room, and the surface of the tile has some hard texture to it. I also have done this multiple times on finished wooden floors, as well as other tile floors. There are always some spots where the caulking has a bubble behind it, or for some reason didn't bond to the, supposedly cleaned, bottom edge of the baseboard. This room had four such blank areas. Those areas are redone, and we have to wait at least another week to trim those spots. After it's all trimmed, the edge will be taped again, and painted with a pointed end brush. It ends up really looking like a perfect fit, even if you get down on your hands, and knees, and look closely. It might seem like it would take a long time, but other than the waiting between steps, it's probably not much difference in actual working time than putting down shoe molding. I've never liked shoe molding, because at the very least it keeps you from being able to push some furniture close to the wall. Also, on tile, it's hard to get shoe to fit perfectly too. The green seen on the bevel of the chisel is a reflection of the Frog tape. The chisel is a black plastic handled Stanley no. 40 sharpened to 20 degrees. The bevel is ground by eye a little sharper than the 20 degree cutting edge, and the sharpening is done with a jig, so the sharpened bevel is a little different than the hand ground part of the bevel, but that makes no effective difference. 5 Quote
gee-dub Posted March 20, 2019 Report Posted March 20, 2019 As always Tom, your tips, techniques and years of experience are a great value to many of us. Thanks for that. 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.