Recommended Posts

Posted

My wife got an old table online which I'm trying to refinish. Unfortunately, the old finish is incredibly hard to remove. I'm sanding it with 50 grit and instead of removing material, it looks like I'm sanding it with 1000 grit. As I sand, it leaves a residue that is super thin and sticks to the table even when I vacuum it. If I don't remove it, sanding does nothing. No matter how long I sand, the sandpaper remains absolutely clean which is what baffles me most. It doesn't form clumps or even gum up. If you see the picture, I've been sanding for over an hour and a half to remove the finish on ONE of the leaves and had to stop because my wrist was starting to hurt. I also tried a belt sander with 40 grit with exact same results. 

I don't know what kind of finish it is but when it gets wet it becomes white almost instantly and it takes a few hours to go back to normal.

Based on this description, can anyone figure out what kind of finish this is and the quickest way of removing it? I've never used chemicals so I wouldn't know what to buy but I'm definitely open to it. It would need to be something I can find in Canada though.

Any help will be greatly appreciated.

table.jpeg

Posted

I used Citistrip last time I refinished and it worked quite well. I think it converted about 90% of the finish into an easily scrap-able goop and then I sanded the remainder off without any issue.

I recall looking into it from a safety perspective and not having any strong concerns about safety. I wore my vapor mask as I would with any finishing process.

  • Like 1
Posted

My rough guess is it's some sort of lacquer and is probably nitrocellulose lacquer. Heat softenes the finish which is probably causing the problems that your seeing with sanding. If it's not nitro it's proably a 2k conversion varnish, think 2 part mixed compound like epoxy. IIRC they both react the same way with heat.

Scraping or planing is usually my go to as well.

If you want to sand lower grits are your solution.

The biggest question is this Is the table solid wood or veneer? If the table isn't solid wood or you don't know stop any sanding or scraping now.

  • Like 2
Posted

I removed quite a bit with a card scraper, but I can get so far with it. At some point, there's diminishing returns; looks like the lower coats are harder than the top ones. I tried denatured alcohol, and it didn't work, so I'm ruling out shellac. I don't have acetone, so I can't test for lacquer, but I'm going to try the Citistrip to see how that does. Thanks for all the advice, much appreciated!

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 72 Guests (See full list)

  • Forum Statistics

    32k
    Total Topics
    437.5k
    Total Posts
  • Member Statistics

    26,007
    Total Members
    3,644
    Most Online
    FurniCore
    Newest Member
    FurniCore
    Joined